Back to overview


Micromechanical modeling of fatigue behavior of DP steels

Wednesday (28.09.2016)
17:45 - 18:00
Part of:

The effect of martensite fraction on the cyclic stress-strain behavior of two DP steels with different martensite phase fractions is investigated utilizing micromechanical modeling by means of a representative volume element (RVE). A dislocation density based model and a Chaboche hardening model are used to identify the isotropic and kinematic hardening behavior of constituent phases, respectively. The Chaboche parameters obtained by fitting flow curves computed from a dislocation density based model for both ferrite and martensite phases of each steel are incorporated into a Finite Element code ABAQUS to simulate the low cycle fatigue with a combined hardening behavior. Based on experimental observations reported in the literature fatigue crack initiates in ferrite phase. A ductile damage model, therefore, is used to simulate damage initiation in ferrite. The results show that the martensite fraction has a significant influence on cyclic plastic strain accumulation during the cyclic deformation. It is also concluded that with an increase in the martensite volume fraction in DP steel, the elastic component of the total strain amplitude increases and higher fatigue strength is, subsequently, observed.

Ghazal Moeini
Bauhaus Universität Weimar
Additional Authors:
  • Dr. Ali Ramazani
    University of Michigan
  • Prof. Ronald Larson
    University of Michigan
  • Prof. Dr. Carsten Könke
    Bauhaus Universität Weimar